![]() ![]() Generally, you can reuse Ponceau S until the signal strength is noticeably lower. The blocking step will remove any residual stain, and will not affect the experiment.įAQs about Ponceau S How many times can I reuse Ponceau S stain? Proceed with blocking the membrane as usual.Wash the membrane 3x with 5 mL of TBS-T or your washing buffer for western blot.You may image the membrane at this point. At this point, the protein bands stained with Ponceau S will be visible.You can save money by reusing the used Ponceau S. Rinse the membrane with distilled water until the background staining is removed.Let the membrane incubate on the benchtop for a minimum of one minute.Cover your membrane with the Ponceau S solution and close the lid to protect it from light.After the transfer of proteins onto your membrane is complete, wash the membrane briefly with distilled water (one minute with rocking is sufficient).Store the prepared solution at either 4☌ or room temperature, but ensure you protect it from light. The final concentration will be 5% v/v glacial acetic acid and 0.1% w/v Ponceau S. To make a 100 mL solution from the powder, weigh 100 mg of Ponceau S powder and make it up to 95 mL with distilled water before adding 5 mL of glacial acetic acid. Ponceau S can be purchased as a pre-made solution or as a dry powder. Read on to find out what these are! Ponceau S Staining Protocol How To Make a Ponceau S Solution If you’ve stained your blot and found a less-than-ideal pattern, it could be indicative of several issues. However, like anything else on the benchtop, things can sometimes go awry. The staining process is typically done on a blot after the transfer step to confirm that the transfer worked well with no issues. ![]() It does not affect the protein structure.Three key benefits of Ponceau S stain to note: Example of Ponceau S staining of a western blot membrane. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |